All our productive process always begin with a special selection of the highest quality raw materials (profiles, aluminium, plate PVC, wood, poliethylene, glues, paintings, etc)

• Matricer: Solder cut and curved of our profiles (panel PM).
• Inlay: Printed sheets. (Panel PT)
• Therma conformed: (Panel PV) Moulded with hot.
• Lacquered with Polystyrene, totally automation (Panel PM and PT).

MANUFACTURE:

• The sandwich.
• Lacquered: Powder Polyester.
• Glue: Of Polyurethane.

For all this, Cursogal panels are quaranteed for 10 years any fault of manufactured process. See conditions.

CHARACTERISTICS	Test	Results
Adherence by cut and grating	UNE-EN-ISO 2409-96	OK
Resistance to Buchholz system	UNE 48252 ISO 2815	OK
Resistance to inlay	UNE-EN-ISO 1520-96	OK
Resistance to fold by cylinder mandrell	UNE-EN-ISO 1519-96	IN AGREEMENT
Resistance test of sawing, drilling and milling cutter.	AIMME	There isn't peeling or detachment of painting coat.
Resistance test to boiling water	AIMME PE-C012	Without blistering
Test Machu	AIMME PE-C024	Intact
Test of Polymerisation grado	AIMME PE-C014	OK
Resistance test to damp	UNE-EN-ISO 6270	Without corrosive process or loss adherence.
Kesternich Test (sulphur dioxide)	UNE-EN-ISO 3231	Without corrosive process or loss adherence.
Test saline-oiled fog	UNE-112-017-92 ISO 92227-90	Without corrosive process or loss adherence.
Resistance test of mortar	AIMME PE-C011	No defect
Test Tabber abrasive	ASTM-D-4060	20% more resistant than normal lacquer
Shine and colour variation 13/05/97	ISO-1134-94
Accelerated to make it old by exposure to radiation Xenon arch.	ISO-2813
Panels follow the test of accelerated to make it old in the shine paragraph. Colour difference, because of the decoration kind can´t be measured by chromatic coordinates and significative the changes can´t be observed. The results obtained in the samples tested to the accelerated to make it old are:
Shine: Initial: 65% Final: 58% Residuary: 89%